Articles

I’m Going to Try the DARPA Lift Challenge 2028

Follow as I attempt to compete in the DARPA Lift Challenge 2028.

Contents
  1. What is the DARPA Lift Challenge?
  2. What changes for 2028?
  3. Watch the 2026 challenge
  4. Why I’m doing this

Follow as I attempt to compete in the DARPA Lift Challenge 2028.


What is the DARPA Lift Challenge?

For those not aware, the DARPA Lift Challenge is a national competition aimed at pushing the limits of heavy vertical-lift aviation.

DARPA describes the challenge as an effort to revolutionize heavy vertical-lift aviation by developing aircraft that can carry dramatically more payload relative to their own weight.

For the 2026 challenge, competitors had to build an aircraft weighing 55 lb or less and complete a five-nautical-mile course while carrying at least 110 lb of payload. The topline ratio goal was a 4:1 payload-to-aircraft-weight ratio.

AVIDrone won the objective competition with a 3.84:1 ratio, carrying 112 lb with a 29 lb aircraft. MTech Operations finished second at 3.64:1, and Xtreme Aerial Concepts finished third at 3.45:1.

The challenge is back for 2028 with a higher bar and a longer course. After the first competition, DARPA said the 4:1 payload-to-weight ratio now looks “possible and likely just the beginning.”

What changes for 2028?

DARPA hasn’t published the full ruleset yet, but the high-level information they have released is the same 55 lb aircraft limit with twice the payload and distance:

  • Aircraft will still be 55 lb or less.
  • The minimum payload doubles from 110 lb to 220 lb.
  • The course doubles from 5 nautical miles to 10 nautical miles: 8 miles loaded and 2 miles unloaded.
  • The preparation timeline expands to two years, allowing more development and testing.
  • DARPA says there will be an increased focus on collaboration within the community.
  • Participation in the 2026 challenge is not required to compete in 2028.

Watch the 2026 challenge

Watch the DARPA Lift Challenge 2026 recap on YouTube

Why I’m doing this

I didn’t hear about the challenge, or what I was hearing didn’t sink in, until the challenge was a week or two around the corner. But it spoke to me enough that I had to make the drive down from Michigan to attend as a spectator.

I know little to nothing about drones, but when I heard about the 2028 competition, I decided that I couldn’t let the opportunity pass me by. I DO have experience designing, testing, and building custom mechatronics systems and their controls. I’m hoping that I can leverage these skills and learn what I need to fast enough.

So to that end, I’ll be using this blog(?) to document and share my journey.